Garage Door Springs – Some Safety Concerns

Garage door springs can pose several safety hazards. A weak spring that breaks can send sharp shrapnel flying pieces in any direction around the garage. If this happens during an annoying situation and someone is inside the garage, it can cause serious injuries.

Today, modern garage doors with recent models of springs pose little risk in the event of spring breakage. These models of springs are installed over a shaft that helps the garage door to go up and downward position. The rod or shaft also works like a retainer so the broken pieces of torsion springs are not allowed to go ballistic material. On the opposite side, the flip-up style garage door can be handled in different ways. Old or weak springs are subject to send ballistic chinks of metal flying around the garage in the case of breakage. Click here https://fayettecountygaragedoorrepair.com/garage-door-springs/ for a free source of information about garage door springs.

Old models of springs can be identified quite easily because recent models of springs are created with a core rod that retains the chunks of broken springs inside the coil. It is a built-in safety feature for your protection because the core rod will hold any chunks of broken springs in the case of breakage. You can inspect these springs at any local hardware store. You can easily inspect the core retaining rod putting with the length of the springs. If your old model of garage door springs does not have such a rod, it is recommended to replace them with a new one. This project can cost up to $100 depending on the locality. It is a simple and affordable technique to make good looking spring as safe as new with almost 1/8 inches cable.

In other cases, close the garage door to expand the springs to their maximum stressed position to measure their length. Double the size and then add two feet more. For example, a garage door spring will be measured 4.5 feet when extended. It means that the double size is 9 feet and it will be 11 feet after adding extra two feet.  You should ass one cable clamp to your shopping list. Run the cable up the center of the spring and to the backside of the spring to form a loop. Use a cable clamp to join the end together. In simple words, you will have to create a retainer to keep the spring secure.

If your garage door has two springs running on each side, you should add another 12 feet to the length and put the cable up the center and down to the center of the other spring. In this way, you will reduce the cost of the project to half. The best technique is to just replace the springs with recent self-retaining models; it can be a hard and dangerous model which costs up to$ 500. Adjustment to garage door springs is a necessary task because the new springs will have different characteristics. The garage door opener will not function properly without proper adjustments. You need to call a professional to make some adjustments and replacements. By spending a few dollars and clamps you can make your springs safer. It just takes few minutes to prevent what could be a scary accident should your old springs break.